Scanning To A Usb Memory Stick Using The Scan To Feature - Xerox WorkCentre series User Manual

Scan
Or
Lift up the document feeder. Place the first segment face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
16. Press the Start button on the control panel to scan the original.
17. Remove the first segment originals after they have been scanned. The Build Job screen displays
the first segment in the list.
18. If required, select the options for the segment.
• Sample Last Segment produces a proof print of the last segment scanned. If you are
satisfied with the proof you can continue programming the Build Job.
• Delete Last Segment deletes the last segment scanned. You can continue programming
the Build Job.
• Delete All Segments deletes the current Build Job and returns you to the main Build Job
screen.
19. Select the features required for the second segment.
20. Load the second segment originals.
21. Press the Start button on the control panel to scan the original.
22. Repeat these steps until all segments of your job have been programmed and scanned.
23. After the last segment has been scanned, select the Submit Job button.
24. Select the OK button.
25. Press the Start button on the control panel to scan the original.
26. Remove the original from the document feeder or document glass when scanning has
completed.
27. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
More Information
Using a User ID to Log In at the Device
Using Internet Services to find System Administrator Contact Details
System Administrator Guide www.xerox.com/support.
Using the Scan To Feature

Scanning to a USB Memory Stick using the Scan To Feature

Use the Scan To... USB option to scan documents directly onto your USB flash drive / memory stick.
Note: This option must be made available by your System Administrator.
Refer to the System Administrator Guide for further information.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Scan To features.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
286
®
WorkCentre XXXX
User Guide