Xerox WorkCentre series User Manual page 114

Copy
Loading the Bypass Tray and Changing the Tray Settings
Loading Different Types of Media
Selecting Exceptions within Copy Sets
When you press the Start button to make a copy, the device scans your originals and temporarily
stores the images. It then prints the images based on the selections made.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Copy features.
Use the Exceptions feature to use a different paper source for a range of pages. For example, you
could print the self test pages in a training guide on different colored paper.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Copy button on the touch screen.
5. If required, select the Copy tab. This is usually the active tab when the Copy service opens.
Note: This feature is not available until a specific paper tray has been selected. It is not
available if the paper Auto Select option is active.
6. Set the Paper Supply required for the main body of the job.
7. Select the Output Format tab.
8. Select the Special Pages button.
9. Select the Exceptions... button.
10. Select each Page Number box in turn and use the numeric keypad to enter the initial and final
page numbers in the exception range.
11. If required, select the paper tray required for the exception. Different paper trays can be
selected for each exception range.
12. Select the Add button.
13. Repeat the previous three steps until all the exceptions have been programmed.
14. Select the Close button to save the information you entered.
15. Select the OK button.
16. Enter the number of prints required using the numeric keypad on the control panel.
17. Press the Start button on the control panel to scan the original.
18. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
19. If your job remains held in the Active Jobs list, the device needs you to supply additional
resources, such as paper or staples before it can complete the job. To find out what resources
are needed, select the job and then select the Details button. Once the resources are available
the job will print.
114
®
WorkCentre XXXX
User Guide