Xerox WorkCentre series User Manual page 697

Hide thumbs Also See for WorkCentre series:

Table of Contents

General Care and Troubleshooting

This finisher and some of its' components are optional and may not be fitted to your device.

If you are unable to resolve the problem, contact the Xerox Support Center.

1. Open the finisher front door.

2. Rotate the indented green knob above label R8 anti-clockwise until the handle is in the

unlocked position.

3. Pinch catch 6 and move it to the left to release any pages trapped in the finisher (pages may

be trapped in both the top and bottom of this area).

4. Remove any jammed pages.

If the page tore while it was being removed, re-assemble the sheet and any pieces to

confirm that nothing has been left in the device.

5. Move catch 6 to the right until it clicks back into position.

6. Rotate the indented knob above label R8 clockwise until the handle is in the locked position.

7. Close the finisher door.

8. If the door does not shut easily check you have returned all the latches to their original position,

then close the door.

More Information

Identifying the Parts of Your Device

Repeated paper jams, misfeeds or multi sheet feeds

Clearing Jams in the New Office Finisher Booklet Maker

Clearing Jams in the Top of the New Office Finisher Booklet Maker

Clearing Jams in the Output Tray of the New Office Finisher Booklet Maker

Clearing Jams in the Booklet Maker Area of the New Office Finisher Booklet Maker

The device displays the status code 12-636-03.

The message on the device touch screen reads: Paper Jam in Finisher. Open the Finisher Front

Troubleshooting