Mazda 3 Workshop Manual – Engine + Wiring Diagrams + Diagnostic Trouble Codes
2. Remove the camshaft caps.
Cylinder Head Removal Note
1. Loosen the cylinder head installation bolts in 2-3 passes in the order shown in the figure, and remove
them.
Cylinder Head Installation Note
1. Measure the length of each cylinder head installation bolt.
• If it exceeds the maximum specification, replace the cylinder head installation bolt.
Standard
L: 128.9-129.5 mm {5.075-5.098 in}
Maximum
L:130.2 mm {5.125 in}
2. Tighten the cylinder head installation bolts in three steps in the order shown in the figure.
Downloaded from
https://carmanualshub.com/
- automotive repair manuals website