Kyocera KM-C2520 Service Manual page 90

2FZ/2F0/2HC
Maintenance
item No.
Operating the DP separately
U203
Description
Simulates the original conveying operation separately in the optional DP.
Purpose
To check the DP operation.
Method
1. Press the start key.
2. Place an original in the DP if running this simulation with paper.
3. Select the item to be operated. The operation starts.
Display
ADP
RADP
ADP (NON P)
RADP (NON P)
4. To stop continuous operation, press the stop/clear key.
Completion
Press the stop/clear key when the operation stops.
The screen for selecting a maintenance item No. is displayed.
Setting the presence or absence of a key card or key counter
U204
Description
Sets the presence or absence of the optional key card or key counter.
Purpose
To run this maintenance item if a key card or key counter is installed.
Setting
1. Press the start key.
2. Select the optional counter to be installed.
Display
KEY-CARD
KEY-COUNTER
3. Press the start key. The setting is set and the screen for selecting a maintenance item No. is displayed.
4. Turn the main power switch off and on.
Setting the presence or absence of the coin vender
U206
Description
Sets the presence or absence of the optional coin vender. Also sets the details for coin vender operation, such
as mode and unit price.
This is an optional device which is currently supported only by Japanese specification machines, so no setting
is necessary.
Checking the operation panel keys
U207
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the start key. The screen for executing is displayed.
2. COUNT1 is displayed and the leftmost LED on the operation panel lights.
3. As the keys lined up in the same line as the lit indicator are pressed in the order from the top to the bot-
tom, the figure shown on the touch panel increases in increments of 1.
When all the keys in that line are pressed and if there are any LEDs corresponding to the keys in the line
on the immediate right, the top LED in that line will light.
4. When all the keys on the operation panel have been pressed, all the LEDs light for up to 10 seconds.
5. When the LEDs go off, press the start key. All the LEDs light for 10 seconds again.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
1-3-50
Description
Description
With paper, single-sided original
With paper, double-sided original
Without paper, single-sided original (continuous operation)
Without paper, double-sided original (continuous operation)
Description
The key card is installed.
The key counter is installed.