Kyocera KM-C2520 Service Manual page 167

Section Jam code
Optional 81
finisher Paper entry sensor non
arrival jam
82
Jam in stapler
83
Exit sensor stay jam
84
Jam in eject section of
right sub tray (3000-sheet
document finisher only)
85
Jam in eject section of left
sub tray (3000-sheet doc-
ument finisher only)
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned off even if a speci-
fied time has elapsed after the machine eject signal was
received.
The paper entry sensor (PES) is not turned on even if a speci-
fied time has elapsed after the machine eject signal was
received.
The paper entry sensor (PES) does not turn off within speci-
fied time of its turning on.
(Document finisher)
The paper entry sensor (PES) is not turned on even if a speci-
fied time has elapsed after the machine eject signal was
received.
(3000-sheet document finisher)
The home position is not detected within the specified time
when driving the staple motor.
(Document finisher)
The staple home position sensor (STSPS) is not turned on
within the specified time when driving the staple motor (STM).
(3000-sheet document finisher)
Eject switch 1 (ESW1) is not turned off within specified time of
its turning on.
(Document finisher)
In the straight mode, the exit sensor (EXS) is not turned off
within specified time of its turning on.
(Document finisher)
In the offset or staple mode, the exit sensor (EXS) is not
turned off within specified time of its turning on.
Eject switch 2 (ESW2) is not turned off even if a specified time
has elapsed after the machine eject signal was received.
Eject switch 2 (ESW2) is not turned on even if a specified time
has elapsed after the machine eject signal was received.
Eject switch 2 (ESW2) is not turned off within specified time of
its turning on.
Eject switch 3 (ESW3) does not turn off within specified time of
paper entry sensor (PES) turning on.
Eject switch 3 (ESW3) does not turn on within specified time of
paper entry sensor (PES) turning on.
Eject switch 3 (ESW3) is not turned off within specified time of
its turning on.
Conditions
2FZ/2F0/2HC-5
Specified
time
1592 ms
1592 ms
3500 ms
2539 ms
600 ms
1000 ms
1404 ms
1680 ms
5375 ms
1828 ms
1828 ms
3500 ms
2157 ms
2157 ms
3500 ms
1-4-7