Kyocera KM-C2520 Service Manual page 258

2FZ/2F0/2HC-4
(2) Detaching and refitting the conveying drive unit
Follow the procedure below to replace the conveying drive unit.
Procedure
1. Pull out cassette 1 and 2.
2. Remove fifteen screws and remove the rear
cover (see page 1-5-9).
3. Remove two straps and remove left cover 2
(see page 1-5-18).
4. Remove three screws and remove left lower
cover 2.
5. Remove the connector cover.
6. Remove the screw, connector and inserted
parts, and then remove the rear cooling fan
motor.
7. Release the wire from the wire saddles of
the conveying drive unit and remove all of
the connectors.
8. Remove four screws and remove the con-
veying drive unit.
1-5-36
Left lower cover 2
Figure 1-5-78
Rear cooling
fan motor
Figure 1-5-79
Wire saddles
Figure 1-5-80
Connector cover
Connector
Conveying drive unit