Kyocera KM-C2520 Service Manual page 291
Hide thumbs
Also See for KM-C2520:
- Advanced operation manual (380 pages) ,
- Operation manual (242 pages) ,
- Set up and operation manual (96 pages)
Table of Contents
Advertisement
(4) Others
19
16
18
18
14
13
8
7
5
6
1.
Hard disk (HDD)........................................... Storages the image data and information of job accounting mode.
2.
Exposure lamp (EL) ..................................... Exposes originals.
3.
MP paper feed clutch (MPPFCL) ................. Controls primary paper feed from the MP tray.
4.
MP paper conveying clutch (MPPCCL) ....... Controls paper conveying from the MP tray.
5.
Paper feed clutch 1 (PFCL1) ....................... Controls primary paper feed from cassette 1.
6.
Paper feed clutch 2 (PFCL2) ....................... Controls primary paper feed from cassette 2.
7.
Paper conveying clutch (PCCL)................... Controls paper conveying from the MP tray.
8.
Registration clutch (RCL)............................. Controls secondary paper feed.
9.
MP solenoid (MPSOL) ................................. Operates up/down of the MP forwarding pulley.
10. LSU cleaning solenoid (LSUCLSOL) ........... Operates the LSU blade for dust shield glass cleaning. (LSU section)
11. LSU cleaning clutch (LSUCLCL).................. Drive the dust shield glass cleaning system. (LSU section)
12. Fuser heater 1 (FH1) ................................... Heats the melt belt (heat roller).
13. Fuser heater 2 (FH2) ................................... Heats the melt belt (heat roller).
14. Fuser heater 3 (FH3) ................................... Heats the press roller.
15. Fuser thermistor 1 (FTH1) ........................... Detects the melt belt (heat roller) temperature.
16. Fuser thermistor 2 (FTH2) ........................... Detects the press roller temperature.
17. Fuser thermistor 3 (FTH3) ........................... Detects the melt belt (heat roller) temperature.
18. Fuser thermostat 1 (FTS1)........................... Prevents overheating of the melt belt (heat roller).
19. Fuser thermostat 2 (FTS2)........................... Prevents overheating of the press roller.
20. Cleaning lamp M (CL-M).............................. Removes residual charge from the drum surface. (Magenta)
21. Cleaning lamp C (CL-C)............................... Removes residual charge from the drum surface. (Cyan)
22. Cleaning lamp Y (CL-Y) ............................... Removes residual charge from the drum surface. (Yellow)
2
15
12
17
23
22
11
10
1
21
20
4
24
Figure 2-2-4 Others
9
3
2FZ/2F0/2HC-3
Machine front
Machine inside
Machine rear
2-2-7
Hide quick links:
Advertisement
Table of Contents
