Kyocera KM-C2520 Service Manual page 280

2FZ/2F0/2HC-3
2-1-6 Fuser section
(1) Fuser section
The fuser section consists of the parts shown in figure below. When paper reaches the fuser section after the secondary
transfer process, it passes between the press roller and melt belt. Pressure is applied by the fuser unit pressure springs so
that the toner on the paper is melted, fused and fixed onto the paper. The melt belt is heated by fuser heaters 1 (FH1) or 2
(FH2) inside the heat roller. The press roller is heated by fuser heater 3 (FH3).
2-1-14
Figure 2-1-19 Fuser section
(1) Belt unit frame
(2) Fuser roller
(3) Melt belt
(4) Heat roller
(5) Belt unit stay
(6) Exit L guide
(7) Fuser heater 1 (FH1)
(8) Fuser heater 2 (FH2)
(9) Fuser heater 3 (FH3)
(10) Left guide cover
(11) Press roller stay
(12) Entrance holder
(13) Press roller
(14) Fuser unit stay
(15) Exit pulley guide
(16) Fuser exit pulley
(17) Fuser left cover
(18) Fuser right cover
(19) Entrance UP guide