Kyocera KM-C2520 Service Manual page 77

Maintenance
item No.
Setting the transfer cleaning voltage
U107
Description
Sets the cleaning control voltage for transfer belt unit.
Purpose
Change settings if an offset has occurred due to the failure of cleaning the transfer belt.
Setting
1. Press the start key.
2. Select the item to be set.
Display
Belt Clean A (F)
Belt Clean A (H)
Belt Clean B (H)
Setting: Transfer belt cleaning voltage (printing)
1. Change the value using the cursor up/down keys.
Display
Width<160
160<=Width<220
220<=Width
*: Old and new transfer belt unit
2. Press the start key. The value is set.
Setting: Transfer belt cleaning voltage (using thick paper)
1. Change the value using the cursor up/down keys.
Display
Width<160
160<=Width<220
220<=Width
*: Old and new transfer belt unit
2. Press the start key. The value is set.
Setting: Transfer belt cleaning voltage (paper interval)
1. Change the value using the cursor up/down keys.
Display
Belt Clean B (F)
Belt Clean B (H)
2. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, copying from an original is available in the interrupt copying
mode.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Description
Description
Transfer belt cleaning voltage (printing)
Transfer belt cleaning voltage (using thick paper)
Transfer belt cleaning voltage (paper interval)
Description
Small sizes (under 160 mm wide)
Medium sizes (160 to under 220 mm wide)
Large sizes (more than 220mm wide)
Description
Small sizes (under 160 mm wide)
Medium sizes (160 to under 220 mm wide)
Large sizes (more than 220mm wide)
Description
Small sizes (under 160 mm wide)
Medium sizes (160 to 220 mm wide)
2FZ/2F0/2HC-5
Setting Default
range setting
0 to 255 64/90*
0 to 255 64/90*
0 to 255 54/90*
Setting Default
range setting
0 to 255 51/55*
0 to 255 51/55*
0 to 255 51/55*
Setting Default
range setting
0 to 255 170
0 to 255 110
1-3-37