Kyocera KM-C2520 Service Manual page 152

2FZ/2F0/2HC
Paper output select
Set the output destination for printed paper. If the optional
document finisher or 3000 sheet document finisher, or
mailbox is installed, you can specify each tray.
1. Press [Paper Handling].
2. Select [Paper Output] using the cursor up/down
keys and press [Change #].
3. Press the desired output destination key.
Top tray/Job separator/Finisher tray/Tray A/Tray B/
Tray C/Tray 1/Tray 2/Tray 3/Tray 4/Tray 5/Tray 6/
Tray 7
4. Press [Close].
Shared A4/letter size feed select
Sets whether to detect A4 and Letter size paper.
1. Press [Paper Handling].
2. Select [Override A4/LT] using the cursor up/down
keys and press [Change #].
3. Press [On] or [Off].
4. Press [Close].
Memory card format (initialization)
Before using a new memory card, the card must first be
formatted.
Format the memory card at the device.
1. Press [Memory Card].
2. Press [Format].
3. Press [Yes].
4. Memory card formatting begins.
Writing data
Print data received from a computer onto the memory
card.
Written data is automatically assigned a name (partition
name).
1. Press [Memory Card].
2. Press [Write Data].
3. Send data from a computer.
4. When done receiving data from the computer, Page
remaining is displayed.
5. Press [GO].
Reading data
Read data, program data, fonts, or macro data saved to a
memory card.
1. Press [Memory Card].
2. In the [Read] area, press [Data], [Program], [Font]
or [Macro].
3. Select the item to be read using the cursor up/down
keys and press [Enter].
4. Data is read from the memory card.
1-3-112
Deleting data
Delete data, program data, fonts, macro data or option
languages saved to a memory card.
1. Press [Memory Card].
2. In the [Delete] area, press [Data], [Program], [Font],
[Macro] or [Language].
3. Select the item to delete using the cursor up/down
keys and press [Delete].
4. Data is deleted from the memory card.
Print list of partitions
Print the memory card contents (data names, data size,
etc.) as a partition list.
1. Press [Memory Card].
2. Press [List of Partitions].
3. Press [Printing].
4. The partition list is printed.
RAM disk operation
Before using the RAM disk function, set RAM disk to [On]
from the RAM disk configuration item and set the RAM
disk size. After RAM disk configuration is complete, per-
form the following operations.
• Write Data
• Print List of Partitions
• Read Data (data, programs)
• Deleting Data (data, fonts, programs, or macros)
The RAM disk function is not available when a hard disk
is installed.
All of its contents are erased when this device is reset or
switched off.
The RAM disk is created from a portion of this device's
memory available for use by users. Therefore, depending
on RAM disk configuration, print speed may be reduced
or printing problems may arise due to insufficient mem-
ory.
RAM disk usage steps are the same as the memory card
usage steps.
RAM disk setting
To use the RAM disk function, set it to [On] (enabled).
1. Press [RAM DISK Mode].
2. Press [On].
3. Press [Close].
4. Press [Yes].
5. This device restarts.