Kyocera KM-C2520 Service Manual page 101

Maintenance
item No.
Setting: adjustment of slanted stapling home position
U246
1. Select [T-STAPLE HP ADJ].
2. Change the setting value using the cursor up/down keys.
Description
Adjustment of slanted stapling home position
To increase the angle for slanted stapling (sample 1), decrease the preset value. To decrease the angle
for slanted stapling (sample 2), increase the preset value.
3. Press the start key. The value is set.
4. To return to the screen for selecting an item, press the stop/clear key.
Method: centerfold unit
1. Select the item to set.
Display
WIDTH U HP ADJ
WIDTH L HP ADJ
STAPLE POS ADJ1
STAPLE POS ADJ2
STAPLE POS ADJ3
BOOKLET POS ADJ1
BOOKLET POS ADJ2
BOOKLET POS ADJ3
Setting: adjustment of upper/lower side registration home position
1. Select [WIDTH U HP ADJ] or [WIDTH L HP ADJ].
2. Change the setting value using the cursor up/down keys.
Description
Adjustment of upper side registration home position
Adjustment of lower side registration home position
3. Press the start key. The value is set.
4. Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
5. Enter maintenance mode U240 and select [BOOKLET], then [WID A3 TEST].
The width guides of the centerfold unit will move to A3-size position.
6. Pull the centerfold unit, insert paper between the guides and check that paper is abut the guides.
7. Repeat the above adjustment until paper is properly in position.
Description
Sample 1
Figure 1-3-16
Description
Adjustment of upper side registration home position
Adjustment of lower side registration home position
Adjustment of booklet stapling position for A4/8.5 x 11 size
Adjustment of booklet stapling position for B4/8.5 x 14 size
Adjustment of booklet stapling position for A3/11 x 17 size
Adjustment of center folding position for A4/8.5 x 11 size
Adjustment of center folding position for B4/8.5 x 14 size
Adjustment of center folding position for A3/11 x 17 size
Setting Default Change in
range setting value per step
-10 to 10 0
0.8
Sample 2
Setting Default Change in
range setting value per step
-20 to 20 0 0.24 mm
-46 to 46 0 0.24 mm
2FZ/2F0/2HC-5
°
1-3-61