Kyocera KM-C2520 Service Manual page 111

Maintenance
item No.
Switching between duplex/simplex copy mode
U343
Description
Switches the initial setting between duplex and simplex copy.
Purpose
To be set according to frequency of use: set to the more frequently used mode.
Setting
1. Press the start key.
2. Select the copy mode.
Display
ON
OFF
Initial setting: OFF
3. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Setting the low-power mode
U344
Description
Changes the control for low-power mode.
Purpose
According to user request, selects which has priority, the recovery time from low-power or energy saver.
Setting
1. Press the start key.
2. Select control mode.
Display
ENERGY STAR
GEEA
Initial setting: ENERGY STAR (120 V specifications)/GEEA (220-240 V specifications)
3. Press the start key. The setting is set, and the screen for selecting a maintenance item No. is displayed.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Setting the value for maintenance due indication
U345
Description
Sets when to display a message notifying that the time for maintenance is about to be reached, by setting the
number of copies that can be made before the current maintenance cycle ends.
When the difference between the number of copies of the maintenance cycle and that of the maintenance
count reaches the set value, the message is displayed.
This maintenance mode is effective for only Japanese specification.
Adjusting margins of image printing
U402
Description
Adjusts margins for image printing.
Purpose
Make the adjustment if margins are incorrect.
Adjustment
1. Press the start key.
2. Select the item.
Display
LEAD
A
C
TRAIL
Description
Duplex copy
Simplex copy
Description
The fuser control temperature is as low-power mode control tempera-
ture and forced stabilization is performed 30 seconds after exiting
preheat.
The fuser control temperature is as low-power mode control tempera-
ture and forced stabilization is performed 30 seconds after exiting
preheat.
Description
Printer leading edge margin
Printer left margin
Printer right margin
Printer trailing edge margin
Description
Setting
range
0 to 10.0
0 to 10.0
0 to 10.0
0 to 10.0
2FZ/2F0/2HC-3
Initial Change in
setting value per step
3.0 0.1 mm
2.5 0.1 mm
2.5 0.1 mm
3.0 0.1 mm
1-3-71