Kyocera KM-C2520 Service Manual page 68

2FZ/2F0/2HC-3
Maintenance
item No.
U076 If a problem occurs during auto adjustment, DATA: XX (XX is replaced by an error code) is displayed
and operation stops. Should this happen, determine the details of the problem and either repeat the
procedure from the beginning, or adjust the remaining items manually by running the corresponding
maintenance items.
Completion
Press the stop/clear key after auto adjustment is complete. The screen for selecting a maintenance item is
displayed.
If press the stop/clear key during auto adjustment, adjustment stops and no settings are changed.
Setting the economy mode
U080
Description
Sets the level in the economy mode.
Purpose
Set according to the preference of the user.
Setting
1. Press the start key.
2. Select the item to be set.
3. Change the setting value using the cursor up/down keys.
Display
ADJUST DATA
ADJUST DATA2
4. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, copying from an original is available in the interrupt copying
mode.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
1-3-28
Code Description
61 Sub scan magnification is above the ± 2.5%
62 Leading timing is above ± 3.2mm
63 Trailing timing is above ± 3.2mm
64 The gap of sub scan direction is above ± 1.5mm
65 The gap of the center line is above ± 3.2mm
67 The gap of main scanning direction is above ± 1.5mm
68 The leading black edge of the adjustment original is not detected.
69 The trailing black edge of the adjustment original is not detected.
6a The right edge black edge of the adjustment original is not detected.
6b The left edge black edge of the adjustment original is not detected.
6f Timeout occurred when reading out from memory.
Description
For full-color mode
For monochrome and single color mode
Description
Setting range
50 to 100
50 to 100
Default
setting
75
75