Front Wheel Related Parts Inspection - Suzuki RMX450Z Service Manual

2D-5 Wheels and Tires:
5) Hold the front axle with the special tool and tighten
the front axle nut (3) to the specified torque.
Special tool
(A): 09944–28321 (Hexagon socket (19
mm))
Tightening torque
Front axle nut (a): 35 N·m (3.5 kgf-m, 25.0 lbf-ft)
(A)
6) Move the front fork up and down 4 or 5 times.
7) Tighten left and right axle pinch bolts (4) on the each
fork leg to the specified torque.
Tightening torque
Front axle holder bolt (b): 18 N·m (1.8 kgf-m,
13.0 lbf-ft)
4
(b)
3
(a)
IA02J1240045-01
IA02J1240041-01
4
(b)
IA02J1240032-01

Front Wheel Related Parts Inspection

Refer to "Front Wheel Assembly Removal and
Installation" (Page 2D-3).
Tire
Refer to "Wheel and Tire Inspection" in Section 0B
(Page 0B-24).
Front Brake Disc
Refer to "Front Brake Disc Inspection" in Section 4B
(Page 4B-6).
Speed Sensor
Refer to "Speed Sensor Inspection" in Section 9C
(Page 9C-4).
Dust Seal
Inspect the dust seal lips for wear or damage. If any
defects are found, replace the dust seal with a new ones.
Refer to "Front Wheel Dust Seal / Bearing Removal and
Installation" (Page 2D-6).
Wheel Axle
Using a dial gauge, check the wheel axle for runout. If
the runout exceeds the limit, replace the axle shaft.
Special tool
(A): 09900–20607 (Dial gauge (1/100 mm, 10
mm))
(B): 09900–20701 (Magnetic stand)
(C): 09900–21304 (V-block (100 mm))
Wheel axle runout
Service limit: 0.25 mm (0.010 in)
(A)
(C)
BA02J22406004
IA02J1240033-01
(B)
I649G1240054-02