Installation Of Transmission - Toyota Supra 1990 Manual

MT-6
MANUAL TRANSMISSION - Removal and Installation of Transmission
MT0306
MT0305
Installation of Transmission
1-1. (R154)
PLACE TRANSMISSION AT INSTALLATION POSITION,
AND INSTALL TRANSMISSION MOUNTING BOLTS
(a) Apply molybdenum disulphide lithium base grease to
the following parts:
• Release bearing hub inside groove
• Input shaft spline
• Release fork contact surface
(b) Install the clutch cover and disc on the retainer and
input shaft spline.
(c) Align the input shaft tip with the pilot bearing, and
push the transmission fully into position.
(d) Install the two mounting bolts of the upper transmis-
sion, and torque the bolts.
Torque: 400 kg-em (29 ft-Ib, 39 Nom)
(e) Align the matchmarks on the clutch cover and
flywheel.
(f)
Tighten the clutch cover set bolts evenly and gradu-
ally while turning the crankshaft pulley. Make sever-
al passes around the cover until the cover is snug.
Torque the bolts.
Torque: 195 kg-em (14 ft-Ib, 19 Nom)
(g) Install the release fork to the release fork support
through the left clutch housing hole.
(h) Install the two clutch housing covers.
Torque: 120 kg-em (9 ft-Ib, 12 Nom)
1-2. (W58)
PLACE TRANSMISSION AT INSTALLATION POSITION,
AND INSTALL TRANSMISSION MOUNTING BOLTS
(a) Align the input shaft spline with the clutch disc, and
push the transmission fully into position.
(b) Install the two mounting bolts of the upper transmis-
sion, and torque the bolts.
Torque: 400 kg-em (29 ft-Ib, 39 Nom)