Cold Start Injector - Toyota Supra 1990 Manual

FI-72 EFI SYSTEM - Fuel System
FI1648
(e) (7M-GTE)
Remove the cold start injector tube.
• Place a suitable container or shop towel under the
cold start injector.
• Slowly loosen the union bolt of the cold start in-
jector tube and remove the bolt and two gaskets
from the cold start injector.
• Remove the union bolt, fuel tube and two gaskets.
(f) (7M-GTE)
Remove the cold start injector.
(See page FI-78)
(g) (7M-GTE)
Install the gasket and cold start injector with the bolts
without connecting the cold start injector connector.
Torque: 55 kg-em (48 in.-Ib, 5.4 N ·m)
(h) Install SST (pressure gauge) to the delivery pipe with
new two gaskets and union bolt.
SST 09268-45012
Torque: 300 kg-em (22 ft-Ib, 29 N·m)
(i)
Wipe off any splattered gasoline.
(j) Reconnect the battery negative (-) cable.
(k) Using SST, connect terminals
+
Band Fp of the check
connector.
SST 09843-1 8020