Toyota Supra 1990 Manual page 445

MANUAL TRANSMISSION - Assembly of Transmission
MT-39
WM0129
WM0130
6. INSTALL FIFTH GEAR AND OUTPUT SHAFT REAR
BEARING
Using SST, install the 5th gear and rear bearing.
SST 09312-20011
7. INSTALL SNAP RING
(a) Select a snap ring that will allow minimum axial play.
Mark Thickness
mm (in.) Mark Thickness
mm (in.)
8
2.31 - 2.36 (0.0909 - 0.0929) 12
2.55 - 2.60 (0.1004 - 0.1024)
9
2.37 - 2.42 (0.0933 - 0.0953) 13 2.61-2.66(0.1028-0.1047)
10
2.43 - 2.48 (0.0957 - 0.0976) 14
2.68 - 2.73 (0.1055 - 0.1075)
11 2.49 - 2.54 (0.0980 - 0.1000) 15
2.74-2.79 (0.1079-0.1098)
(b) Using a screw driver and hammer, install snap ring.
8. INSTALL NO.3 CLUTCH HUB
Using SST, drive in NO.3 clutch hub.
SST 09316-60010 (09316-00010, 09316-00070)
HINT:
When installing the clutch hub, support the coun-
tershaft in front with a 3-5 Ib hammer or equivalent.
9. INSTALL SNAP RING
(a) Select a snap ring that will allow minimum axial play.
Mark Thickness
mm (in.)
2
2.06 - 2.11 (0.0811 - 0.0831)
3
2.12 - 2.17 (0.0835 - 0.0854)
4 2.18 - 2.23 (0.0858 - 0.0878)
5
2.24 - 2.29 (0.0882 - 0.0902)