Toyota Supra 1990 Manual page 123

ENGINE MECHANICAL - Cylinder Block EM-91
(a) Align the bearing claw with the claw groove of the
main bearing cap or cylinder block.
(b) Install the bearing in the cylinder block and bearing
caps.
NOTICE: Install the bearing with the oil hole in the block.
3. INSTALL UPPER THRUST WASHERS
Install the thrust washers under the No.4 main journal po-
sition of the block with the oil grooves facing outward.
4. PLACE CRANKSHAFT ON CYLINDER BLOCK
5. INSTALL MAIN BEARING CAPS AND LOWER THRUST
WASHERS
HINT: Each bearing cap has a number and front mark.
(a) Install the thrust washers on the No.4 bearing cap
with the grooves facing outward.
(b) Install the bearing caps in numbered order with arrows
facing forward.
(c) Install and uniformly tighten the fourteen cap bolts in
several passes, in the sequence shown.
Torque: 1,040 kg-cm (75 ft-Ib, 102 N·m)
(d) Check that the crankshaft turns smoothly.
(e) Check the crankshaft thrust clearance.
(See step 21 on page EM-71)