Toyota Supra 1990 Manual page 436

Hide thumbs Also See for Supra 1990:

Table of Contents

MANUAL TRANSMISSION -

Component Parts (Counter Gear and Reverse Idler Gear)

MEASURE CLEARANCE OF SHIFT FORKS AND HUB

Using a feeler gauge, measure the clearance between the

hub sleeve and shift fork.

Maximum clearance:

1.0 mm (0.039 in.)

If the clearance exceeds the limit, replace the shift fork or

REPLACEMENT OF BEARING

IF NECESSARY, REPLACE COUNTER GEAR FRONT BEAR-

ING AND SIDE RACE

Using snap ring pliers, remove the snap ring.

Using a press and SST, press out the bearing.

SST 09950-00020

Check the side race for wear or damage.

If necessary, remove the side race.

• Using SST and socket wrench, remove the side

SST 09950-20017

Using a socket wrench, press in a new bearing, side

race and inner race.

Select a snap ring that will allow minimum axial play

and install it on the shaft.

2.05 - 2.10 (0.0807 - 0.0827)

2.10 - 2.15 (0.0827 - 0.0846)

2.15 - 2.20 (0.0846 - 0.0866)

2.20 - 2.25 (0.0866 - 0.0886)

2.25 - 2.30 (0.0886 - 0.0906)

2.30 - 2.35 (0.0906 - 0.0925)

2.35 - 2.40 (0.0925 - 0.0945)

Chapters

Table of Contents