Toyota Supra 1990 Manual page 12

IN-10 INTRODUCTION - Precautions for Vehicles Equipped with
SRS
Airbag
3. Grease should not be applied to the steering wheel pad
and the pad should not be cleaned with detergents of any
kind.
4. Store the steering wheel pad where the ambient temper-
ature remains below 93°C (200°F), without high humid-
ity and away from electrical noise.
5. When using electric welding, first disconnect the airbag
connector (yellow color and 2 pins) under the steering
column near the combination switch connector before start-
ing work.
6. When disposing of a vehicle or the steering wheel pad
alone, the airbag should be deployed using an SST be-
fore disposal (See page AB-82). Perform the operation
in a place away from electrical noise.
CENTER AIRBAG SENSOR ASSEMBLY
The connector to the center airbag sensor assembly should be
connected or disconnected with the sensor mounted on the
floor. If the connector is connected or disconnected while the
center airbag sensor assembly is not mounted to the floor, it
could cause undesired ignition of the airbag system.
WIRE HARNESS AND CONNECTOR
The airbag system's wire harness is integrated with the cowl
wire harness assembly. The wires for the airbag wire harness
are encased in a yellow corrugated tube. All the connectors for
the system are also a standard yellow color. If the airbag
system wire harness becomes disconnected or the connector
becomes broken due to an accident, etc., repair or replace it as
shown on page AB-21.