Toyota Supra 1990 Manual page 369

Bearing
Idl~~~\YQ,
• '
O~\'
Clutch Assembly
STARTING SYSTEM -
Starter
ST-9
ST0531
ST0282
ASSEMBLY OF STARTER
(See page
ST
-3)
HINT: Use high-temperature grease to lubricate the bear-
ings and gears when assembling the starter.
1. PLACE ARMATURE INTO FIELD FRAME
Apply grease to the armature bearings and insert the ar-
mature into the field frame.
2. INSTALL BRUSH HOLDER
(a) Using a screwdriver, hold the brush spring back, and
connect the brush into the brush holder. Connect the
four brushes.
HINT: Check that the positive (+) lead wires are not
grounded.
(b) Place a new O-ring on the field frame.
(c) Install the end cover to the field frame.
3. INSERT STEEL BALL INTO CLUTCH SHAFT HOLE
(a) Apply grease to the steel ball.
4.
(b) Insert the steel ball into the clutch shaft hole.
INSTALL GEARS AND CLUTCH ASSEMBLY
(a) Apply grease to the gears and clutch assembly.
(b) Place the clutch assembly, idle gear, bearing and pin-
ion gear in the starter housing .
5. INSTALL STARTER HOUSING
(a) Apply grease to the return spring.
(b) Insert the return spring into the magnetic hole.