Toyota Supra 1990 Manual page 96

EM-64 ENGINE MECHANICAL - Cylinder Block
EM2964
REMOVAL OF ENGINE
1 . REMOVE HOOD
2. DISCONNECT CABLE FROM NEGATIVE TERMINAL OF
BATTERY
3.
4.
5.
6.
CAUTION: Work must be started after approx. 20 se-
conds or longer from the time the ignition switch is turned
to the "LOCK" position and the negative (- I terminal ca-
ble is disconnected from the battery.
REMOVE ENGINE UNDER COVER
DRAIN COOLANT FROM RADIATOR AND CYLINDER
BLOCK
(See page CO-51
DRAIN ENGINE OIL
(7M-GEI
REMOVE AIR CLEANER CASE WITH HOSES
(a) Disconnect the air flow meter connector.
(b) Disconnect the PS air hose.
(c) Remove the three bolts and air cleaner case with
hoses.
(7M-GTE)
REMOVE NO.4 AIR CLEANER PIPE WITH NO.1 AND
NO.2 AIR CLEANER HOSES
7. REMOVE NO.7 AIR CLEANER HOSE WITH AIR FLOW
METER AND AIR CLEANER CAP
(a) Disconnect the three air hoses and PCV hose.
(b) Disconnect the air flow meter connector.
(c) Disconnect the PS air hose.
8. REMOVE RADIATOR
(See page CO-9)
9. REMOVE AIC BELT
10. REMOVE ALTERNATOR DRIVE BELT, WATER PUMP
PULLEY AND FLUID COUPLING
11. REMOVE PS BELT
12. DISCONNECT FOLLOWING HOSES:
(a) Brake booster hose
(b) Heater valve hose
(c) Cruise control hose
(d) Charcoal canister hose