Toyota Supra 1990 Manual page 5

INTRODUCTION - How to Use This Manual
IN-3
Illustration:
what to do and where
The procedures are presented in a step-by-step format:
• The illustration shows
what
to do and
where
to do it.
• The task heading tells
what
to do.
• The detailed text tells
how
to perform the task and gives
other information such as specifications and warnings.
Example: /
Task heading: what to do
21.
CHECK PISTON STROKE OF OVERDRIVE BRAKE
(a) Place SST and a dial indicator onto the overdrive
brake piston as shown in the figure.
SST 09350-30020 (09350-06120)
/
~
Set part No. Component part No.
~
Detailed text: how to do task
(b) Measure the stroke applying and releasing the com-
pressed air (4 - 8 kg/cm2, 57 - 114 psi or 392 - 785
kPa) as shown in the figure.
Piston stroke: 1.40 - 1.70 mm (0.0551 - 0.0669 in.)
~
Specification
This format provides the experienced technician with a FAST
TRACK to the information needed. The upper case task head-
ing can be read at a glance when necessary, and the text below
it provides detailed information. Important specifications and
warnings always stand out in bold type.
REFERENCES
References have been kept to a minimum. However, when they
are required you are given the page to refer to.
SPECIFICATIONS
Specifications are presented in bold type throughout the text
where needed. You never have to leave the procedure to look
up your specifications. They are also found in Appendex A,
for quick reference.
CAUTIONS, NOTICES, HINTS:
• CAUTIONS are presented in bold type, and indicate there is
a possibility of injury to you or other people.
• NOTICES are also presented in bold type, and indicate
the possibility of damage to the components being repaired.
• HINTS are separated from the text but do not appear in
bold. They provide additional information to help you
efficiently perform the repair.