Toyota Supra 1990 Manual page 405

Flywheel
Side
...
7M-GE
7M-GTE
6 2,5
(~
B 1998 CL0321
CL0450
SST
CL0425 CL0426
CL0352
CL0468
CLUTCH - Clutch Unit
INSTALLATION OF CLUTCH UNIT
(See page CL-11)
(7M-GE)
1_ INSTALL CLUTCH DISC ON FLYWHEEL
Using SST, install the disc on the flywheel.
SST 09301-20020
2_ INSTALL CLUTCH COVER
CL-15
(a) Align the matchmarks on the clutch cover and
flywheel.
(b) Torque the bolts on the clutch cover in the order
shown.
Torque: 195 kg-em (14 ft-Ib, 19 N·m)
HINT: Temporarily tighten the No.1 and No.2 bolts.
3. CHECK DIAPHRAGM SPRING TIP ALIGNMENT
Using a dial indicator with roller instrument, check the
diaphragm spring tip alignment.
Maximum non-alignment: 0.5 mm (0.020 in.)
If alignment is not as specified, using SST, adjust the di-
aphragm spring tip alignment.
SST 09333-00013
5. APPLY MOLYBDENUM DISULPHIDE LITHIUM BASE
GREASE (NLGI NO.2) OR MP GREASE
(a) Apply molybdenum disulphide lithium base grease to
the following parts.
• Release fork and hub contact point
• Release fork and push rod contact point
• Release fork pivot point
• Clutch disc spline
• Release bearing hub inside groove
(b) Apply MP grease to the front surface of the release
bearing.