Toyota Supra 1990 Manual page 447

MANUAL TRANSMISSION - Assembly of Transmission MT-41
WM0140
E9802
WM0149
WM0150
(b) Using a snap ring pliers, install snap ring.
13. INSTALL SPEEDOMETER DRIVE GEAR
(a) Put a clip on the output shaft and install the drive gear
clip into the slot.
(b) Slide the drive gear with clip and fit the clip into the
holes.
14. MEASURE COUNTER FIFTH GEAR THRUST CLEARANCE
Using a feeler gauge, measure counter 5th gear thrust
clearance.
Standard clearance: 0.10 - 0.41
mm
(0.0039 - 0.0161 in.)
15. INSTALL SHIFT FORKS, SHIFT FORK SHAFTS AND
REVERSE IDLER GEAR
(a) Install the reverse idler gear and shaft.
(b) Install No.3 shift fork, No.3 fork shaft and reverse shift
arm.
(1) Coat the pin with MP grease and insert it into the
reverse shift head hole.
(2) Insert No.3 shift fork shaft through No.3 shift
fork and the reverse shih arm.
(3) Align No.3 shift fork with the No.3 hub sleeve
groove, put the reverse shift arm into the pivot
of bearing retainer and align the reverse shift arm
shoe with the reverse idler gear groove .Install
No.3 shift fork shaft to the intermediate plate.