Toyota Supra 1990 Manual page 397

CLUTCH - Clutch Master Cylinder CL-7
. . . . .
~:§itp
B,,, G Iyool G co",
i
H \ \
~~
~0010
Front
...
INSPECTION OF MASTER CYLINDER
HINT: Clean the disassembled parts with compressed air.
1. INSPECT MASTER CYLINDER BORE FOR SCORING OR
CORROSION
If a problem is found, clean or replace the cylinder.
2. INSPECT PISTON AND CUPS FOR WEAR, SCORING,
CRACKS OR SWELLING
If either one requires replacement, use the parts from the
cylinder kit .
3. INSPECT PUSH ROD FOR WEAR OR DAMAGE
If necessary, replace the push rod.
ASSEMBLY OF MASTER CYLINDER
(See page CL-6)
1. COAT PARTS WITH LITHIUM SOAP BASE GLYCOL
GREASE, AS SHOWN
2. INSERT PISTON INTO CYLINDER
3. INSTALL PUSH ROD ASSEMBLY WITH SNAP RING
4. INSTALL RESERVOIR TANK
Torque: 250 kg-em (18 ft-Ib, 25 N·m)
INSTALLATION OF MASTER CYLINDER
(See page CL-6)
1. POSITION MASTER CYLINDER AND CONNECT CLUTCH
LINE UNION
CL0469
First finger-tighten the union nut and then tighten it to speci-
' - - - - - - - - - - - - - - - - - ' fied torque with SST.
2.
SST
3.
4.
CL0209
5.
6.
7.
SST 09751-36011
Torque: 155 kg-em (11 ft-Ib, 15 N·m)
INSTALL AND TIGHTEN MOUNTING NUTS
INSTALL PUSH ROD ASSEMBLY TO CLUTCH PEDAL
Secure the clevis pin with the spring washer and clip.
BLEED CLUTCH SYSTEM
(See page CL-4)
CHECK FOR LEAKS
CHECK AND ADJUST CLUTCH PEDAL
(See page CL-3)
INSTALL INSTRUMENT LOWER FINISH PANEL AND AIR
DUCT