Toyota Supra 1990 Manual page 358

IG-24
IGNITION SYSTEM - Cam Position Sensor (7M-GTE)
F4B63
F560B
E1BB5
EM6252
(c) Using a punch and hammer, peen both ends of the pin.
INSTALLATION OF CAM POSITION SENSOR
1. CHECK NO.1 CYLINDER TO TOC/COMPRESSION
(See page IG-21)
2.
INSTALL CAM POSITION SENSOR
(a) Install a new a-ring to the cam position sensor.
NOTE: Always use a new a-ring when installing the cam
position sensor.
(b) Align the drilled mark on the driven gear with the
groove of the housing.
(c) Insert the cam position sensor, aligning the center of
the flange with that of the bolt hole on the cylinder
head.
(d) Lightly tighten the hold-down bolt.
3. INSTALL PS RESERVOIR TANK
Install the PS reservoir tank with bracket with the two bolts
and nut.
4.
INSTALL NO.7 AIR CLEANER HOSE WITH AIR FLOW
METER AND AIR CLEANER CAP
(a) Install the No.7 air cleaner hose with the air flow meter
and air cleaner cap.
(b) Install the bolt and tighten the clamps.