Toyota Supra 1990 Manual page 250

FI-76 EFI SYSTEM - Fuel System
F 11653
F 10934
F 10933
Fulcrum Length
2 - 7
mm
(0.08 - 0.28
in.)
Pipe
I
Hose
r------l~----
........ - - - -
II
Clip
0- 3
mm
(0 - 0.12
in.)
.
:to~c"p
U
FI1654
F U0041
F 10494
5. REMOVE FUel PUMP FilTER FROM FUEL PUMP
(a) Remove the rubber cushion.
(b) Remove the clip and pull out the filter.
INSTALLATION OF FUEL PUMP
(See page FI-75)
1. INSTAll FUEL PUMP FilTER TO FUel PUMP
2. INSTAll FUel PUMP TO FUel PUMP BRACKET
(a) Insert the outlet port of the fuel pump into the fuel
hose.
(b) Install the rubber cushion to the lower side of the fuel
pump.
(c) Push the lower side of the fuel pump, together with
the rubber cushion, into the fuel pump bracket.
3. INSTAll FUel PUMP BRACKET
(a) Place the bracket with a new gasket on the fuel tank.
(b) Install and torque the six screws.
Torque: 35 kg-cm (30 in.-Ib, 3.4 N ·m)
4. INSTAll FUel TANK
(a) Apply a thin coat of oil to the flare and tighten the
flare nut.
(b) Then using SST, tighten the nut to the specified
torque.
SST 09631-22020
Torque: 310 kg-cm (22 ft-Ib, 30 N·m)
HINT: Use a torque wrench with a fulerum length 30 cm
(11.81 in.).
NOTICE:
• Tighten the fuel tank mounting bolts, etc. to the speci-
fied torque.
• Push in the pipe and insert-type hose to the specified
position, and install the clip to the specified location .
• If reusing the hose, reinstall the clip at the original lo-
cation.
5. REFill GASOLINE