Toyota Supra 1990 Manual page 124

EM-92 ENGINE MECHANICAL - Cylinder Block
6. INSTALL PISTON AND CONNECTING ROD ASSEMBLIES
(a) Cover the connecting rod bolts with a short piece of
hose to protect the crankshaft from damage.
(b) Using a piston ring compressor, push the correctly
Front Mark numbered piston and connecting rod assemblies into
each cylinder with the front mark of the piston fac-
ing forward.
7. INSTALL CONNECTING ROD CAPS
(a) Match the numbered cap with the numbered connect-
ing rod.
(b) Install the cap with the protrusion facing forward.
(c) Apply a light coat of engine oil on the threads and un-
der the nuts of the connecting rod cap.
(d) Install and alternately tighten the cap nuts in several
passes.
Torque: 650 kg-em (47 ft-Ib, 64 N ·m)
(e) Check that the crankshaft turns smoothly.
(f) Check the connecting rod thrust clearance.
(See step 18 on page EM-68)
8. INSTALL OIL PUMP ASSEMBLY
(a) Clean the oil pump.
(b) Install the oil pump with the two bolts and union nut.
Torque the bolt and union nut.
Torque: Bolt (A) 220 kg-em (16 ft-Ib, 22 N·m)
Bolt (B) 60 kg-em (52 in.-Ib, 5.9 N·m)
Union nut 350 kg-em (25 ft-Ib, 34 N·m)