Toyota Supra 1990 Manual page 471

Front
. .
MANUAL TRANSMISSION -
Component Parts (Output Shaft Assembly)
MT-65
D6635 D6644
GM0060
WMOl16
GM0047
ASSEMBLY OF OUTPUT SHAFT ASSEMBLY
1. INSERT NO.1 AND NO.2 CLUTCH HUB INTO HUB SLEEVE
(a) Install the clutch hub and shifting keys to the hub
sleeve.
(b) Install the shifting key springs under the shifting keys.
NOTICE: Install the key springs positioned so that their
end gaps are not in line.
2. INSTALL THIRD GEAR AND NO.2 HUB SLEEVE ON OUT-
PUT SHAFT
(a) Apply gear oil to the shaft and needle roller bearing.
(b) Place the synchronizer ring on the gear and align the
ring slots with the shifting keys.
(c) Install the needle roller bearing in the 3rd gear.
(d) Using a press, install the 3rd gear and No.2 hub sleeve.
3. INSTALL SNAP RING
(a) Select a snap ring that will allow minimum axial play.
Mark Thickness mm (in.)
A
1.80 - 1.85 (0.0709 - 0.0728)
B
1.85 - 1.90 (0.0728 - 0.0748)
C
1.90 - 1.95 (0.0748 - 0.0768)
D 1.95 - 2.00 (0.0768 - 0.0787)
E 2.00 - 2.05 (0.0787 - 0.0807)
F 2.05 - 2.10 (0.0807 - 0.0827)
G
2.10 - 2.15 (0.0827 - 0.0846)
(b) Using snap ring pliers, install the snap ring.