Toyota Supra 1990 Manual page 379

CHARGING SYSTEM - Alternator
CH-7
REMOVAL OF ALTERNATOR
1. DISCONNECT CABLE FROM NEGATIVE TERMINAL OF
BATTERY
CAUTION: Work must be started after approx. 20 se-
conds or longer from the time the ignition switch is turned
to the "LOCK" position and the negative (-) terminal ca-
ble is disconnected from the battery.
2. DISCONNECT WIRING FROM ALTERNATOR
L -_ _ _ _ _ _ .:....-_ _ _ _ _ _
C_H_04_64--1
(a) Disconnect the connector from the alternator.
CH0469
CH0608
CH0635
CH0607
(b) Remove the nut and disconnect the wire from the al-
ternator.
3. REMOVE ALTERNATOR DRIVE BELT
Loosen the alternator pivot bolts, adjusting nut and lock
bolt and remove the alternator drive belt.
4. REMOVE ALTERNATOR
(a) Remove the pivot bolt, nut and adjusting lock bolt.
(b) Remove the alternator.
DISASSEMBLY OF ALTERNATOR
(See page CH-6)
1. REMOVE REAR END COVER
(a) Remove the nut and terminal insulator from the posi-
tive
(+)
terminal.
(b) Remove the three nuts and rear end cover.
2. REMOVE BRUSH HOLDER AND IC REGULATOR
(a) [7M-GE (AfT) and 7M-GTE]
Remove the brush holder cover from the brush holder.
(b) Remove the five screws, brush holder and
Ie
regulator.