Toyota Supra 1990 Manual page 364

ST-4 STARTING SYSTEM - Starter
DISASSEMBLY OF STARTER
(See page ST -3)
1. REMOVE FIELD FRAME WITH ARMATURE FROM
MAGNETIC SWITCH ASSEMBLY
(a) Remove the nut and, disconnect the lead wire from
the magnetic switch terminal.
(b) Remove the two through bolts. Pull out the field frame
with the armature from the magnetic switch assembly.
ST0528 ST0527
(c) Remove the O-ring.
~--------------------~~~~
ST02S1
STOO09
ST0531
2. REMOVE STARTER HOUSING FROM MAGNETIC SWITCH
ASSEMBLY
(a) Remove the two screws.
(b) Remove the starter housing with the pinion gear, idle
gear, bearing and clutch assembly.
3. REMOVE CLUTCH ASSEMBLY AND GEARS FROM
STARTER HOUSING
4. REMOVE STEEL BALL AND SPRING
Using a magnetic finger, remove the spring and steel ball
from the clutch shaft hole.
5. REMOVE BRUSHES AND BRUSH HOLDER
(a) Remove the end cover from the field frame.
(b) Remove the O-ring.
(c) Using a screwdriver, hold the spring back and discon-
nect the brush from the brush holder. Disconnect the
four brushes and remove the brush holder.
6. REMOVE ARMATURE FROM FIELD FRAME