Toyota Supra 1990 Manual page 120

EM-SS
SST
Cut Position
., to
ENGINE MECHANICAL - Cylinder Block
EM4554
EM4587
.~
Tape
EM0282 EM1750
EM1797
3. REPLACE OIL PUMP DRIVE SHAFT OIL SEAL
A. If the timing belt case is removed from the cylinder
block:
(a) Using a screwdriver and hammer, tap out the oil seal.
(b) Using SST and a hammer, tap in a new oil seal.
SST 09214-41010
(c) Apply MP grease to the oil seal lip.
B. If the timing belt case is installed to the cylinder block:
(a) Using a knife, cut off the lip of the oil seal as shown.
(b) Using a screwdriver, pry out the oil seal.
NOTICE: Be careful not to damage the crankshaft. Tape
the screwdriver tip.
(c) Check the oil seal lip contact surface of the pump drive
shaft for cracks or damage .
(d) Apply MP grease to a new oil seal lip.
(e) Using SST and a hammer, tap in the oil seal.
SST 09214-41010