Toyota Supra 1990 Manual page 11

Hide thumbs Also See for Supra 1990:

Table of Contents

INTRODUCTION - Precautions for Vehicles Equipped with

FRONT AIRBAG SENSOR

Never reuse the front airbag sensors involved in a collision

when the airbag has deployed (Replace both the left and

right airbag sensors).

Install the front airbag sensor with the arrow on the sen-

sor facing toward the front of the vehicle.

The front airbag sensor set bolts have been anti-rust

When the sensor is removed, always replace the set bolts

with new ones.

The front airbag sensor is equipped with an electrical con-

nection check mechanism. Be sure to lock this mechan-

ism securely when connecting the connector. If the

connector is not securely locked, a malfunction code will

be detected by the diagnosis system (See page AB-9).

SPIRAL CABLE (IN COMBINATION SWITCH)

The steering wheel must be fitted correctly to the steering

column with the spiral cable at the neutral position, otherwise

cable disconnection and other troubles may result. Refer to page

AB-16 of this manual concerning correct steering wheel instal-

STEERING WHEEL PAD (WITH AIRBAG)

When removing the steering wheel pad or handling a new

steering wheel pad, it should be placed with the pad top

surface facing up. In this case, the twin-lock type connec-

tor lock lever should be in the locked state and care should

be taken to place it so the connector will not be damaged.

And do not store a steering wheel pad on top of another

one (Storing the pad with its metallic surface up may lead

L....:::================~

...:A~B~01~2~8

to a serious accident if the airbag inflates for some reason).

Never measure the resistance of the airbag squib (This

may cause the airbag to deploy, which is very danger-

AB0014 AB0181 AB0110

Chapters

Table of Contents