Table of Contents
Advertisement
S
ETTING THE
A distance adjust parameter setting screen is displayed for the cutter-pen
condition numbers for which DISTANCE ADJUST has been specified.
1
Press the function key F1 through F4 corresponding to the cutter-pen setting
area for which DISTANCE ADJUST has been specified. (Number 4 is used for
the explanations in this section.)
2
Press the CONDITIONS key. The following menu appears.
3
Press the ENTER key. (If tangential emulation has also been enabled for the
same condition number, the overcut setting screen is displayed. In this case
press the ENTER key once again.)
If you wish to adjust the distance in the X-axis direction, press the F2 key to
select X =. If you wish to adjust the distance in the Y-axis direction, press the
F3 key to select X =. Use the (
value at the cursor position in the range from -2.00 to +2.00 (%). To reset the
values to the default value (0.00%), press the F4 key (RESET).
4
Press the ENTER key to register your setting(s).
CAUTION: If cutting or plotting is performed using condition settings for which different
DISTANCE ADJUST settings were specified, the cutting or plotting will not be
aligned. If you change the settings on the same drawings, make the same DIS-
TANCE ADJUST settings.
This setting is retained in the plotter's memory even when the power is turned
off.
A DV A N C E D F U N C T I O NS A ND O P E R A T I O NS : S e t t i n g t h e D I S T A N C E A DJ U S T F u n ct i o n
D
A
P
ISTANCE
DJUST
ARAMETER
CONDITION 4
READY
CONDITION 4
DISTANCE ADJUST
CONDITION4 L= 0.00%
) POSITION keys to increase or lower the
25
10
4
CB15U-K30x 0
SET
25
10
4
CB15U-K30x 0
W= 0.00%
RESET>
6-57
Advertisement
Table of Contents
