Table of Contents
Advertisement
5-4
5.4 Using the PRE FEED Function
The PRE FEED function is used to prevent the loaded media from slipping by
automatically advancing the media the specified length and imprinting it with grit
roller marks. This function can also be used to acclimate long media lengths to the
operating environment in order to minimize media expansion and contraction, and
to ensure stable media feed operations.
1
2
3
4
5
6
CAUTION:• The PRE FEED operation starts immediately once the feed length has been
B AS I C F U N CT I O N S A N D O P E RA T I O N S : U s i n g t h e P R E F E E D F u n ct i o n
S
P
ETTING
ROCEDURE
Press the MENU key.
The following menu appears. Press the NEXT key.
Note: ASSIGN PEN is only displayed for 2-pen models.
Press the F3 key (PRE FEED). The following menu appears.
Use the (
) POSITION keys to increase or decrease the value in the range
from 1 to 50 (m).
Press the ENTER key to register your setting. The plotter will start the feed
operation.
Press the MENU key to return the plotter to Ready status.
If the NEXT key is pressed during a PRE FEED operation, the operation will be
suspended at that point and the media returned to its original position.
specified and the ENTER key pressed. Make sure that there are no obstruc-
tions at the front or rear of the plotter.
• When using roll media, either extend and load the length to be used before-
hand or use the media feed procedure ("5.4 Using the PRE FEED Function",
"6.2 Setting AUTO PRE FEED").
Beginning cutting or plotting without feeding the media first may generate a
position error or may cause the roll media to fall off the stock shaft.
ASSIGN PEN>
CROSS CUT>
PRE FEED>
MOVE STEP>
FEED LENGTH
1 m
Advertisement
Table of Contents
