Table of Contents
Advertisement
6-24
2
3
4
5
A DV A N C E D F U N C T I O NS AN D O P E R AT I O NS : S e t ti n g th e R eg i s tr a t i o n M a rk M o d e
If you wish to skip the registration mark sensing function, press the F2 key
(SKIP) to return the plotter to Ready status.
If you press the F3 key (AUTO), sensing begins from the current pen position.
Use the POSITION keys to move the pen tip to the shaded area in the following
diagrams, and then press the F3 key.
Registration mark pattern 1
Point 2
Point 1 (the desired
Origin Point)
Point 3
Move the pen tip within this area
The plotter will start scanning the registration marks in accordance with the
distance between the marks that was stored under the selected number in the
registration mark reading area (see Section 6.13, "Setting the Registration
Mark Reading Area" for further details).
If you press the F4 key (MANUAL), the following message appears.
MOVE TO MARK 1
USE THE POSITION KEY TO
MOVE THE PEN AND
THEN PRESS ENTER!!.
Use the POSITION keys to move the pen tip to MARK 1 (Point 1), and then
press the ENTER key.
Registration mark pattern 1
Point 2
Point 1 (the desired
Origin Point)
Point 3
Move the pen tip within this area
When Point 1 has been scanned, move the pen tip to MARK 2 (within the Point
2 area) and then to MARK 3 (within the Point 3 area), and perform the same
operation as for Point 1.
When all three points have been scanned automatically or manually, the
display changes to the following (only displayed if OFF has been selected for
DISTANCE ADJUST). The measured value for the distance between points 1
and 2 is shown in the 3rd row. Set the actual distance in the 4th row.
DISTANCE
POINT 1-2
OK?
Registration mark pattern 2
Point 2
Point 1 (the desired
Origin Point)
Point 3
100mm
100mm
Move the pen tip within this area
Registration mark pattern 2
Point 1 (the desired
Origin Point)
Point 3
Move the pen tip within this area
00099.8 mm
00100.0 mm
Point 2
Advertisement
Table of Contents
