6.25 Setting the PEN UP SPEED
This function allows you to set the traveling speed of the pen in the raised status.
When using media that is difficult to cut (such as hard media or soft media), the
pen-down speed must be set to a slow speed. Setting the pen-up speed to a fast
speed reduces the overall cutting time.
1
2
3
4
5
6
7
S
P
ETTING
ROCEDURE
Press the MENU key.
Press the NEXT key until the following menu appears.
Press the F3 key (OPTION 1). The following menu appears.
Press the F1 key (PEN UP SPEED). The following menu appears.
Use the (
) POSITION keys to change the pen-up speed. The pen-up speed
can be set to AUTO, 10, 20, 30, 40, 50, or 60. If AUTO is selected the pen-up
speed is the same as the current pen-down speed.
Press the ENTER key to register your setting.
Press the MENU key to return the plotter to Ready status.
This setting is retained in the plotter's memory even when the power is turned
off.
A DV A N C E D F U N C T I O NS AN D O P E R A T I O NS : S e t t i n g th e P E N U P S P E E D
PEN UP/DOWN>
BACKGROUND SETTINGS>
OPTION 1>
OPTION 2>
PEN UP SPEED>
OFFSET ANGLE>
OFFSET FORCE>
STEP PASS>
PEN UP SPEED
SPEED = AUTO
6-51