Replacing The Cross-Cutter Unit - GRAPHTEC FC7000 Series User Manual

1 - 14

1.6 Replacing the Cross-Cutter Unit

1
2
3
O u t o f t h e B o x : R ep l a ci n g th e C ro s s - C u t t er U n i t
Check that the power switch is turned off (the " " side is pressed down).
Remove the screw holding the cross-cutter unit in place, and then remove the
cross-cutter unit.
Remove the protective cover from the replacement cross-cutter unit. Be sure
to remove the protective cover while holding the part of the unit shown in the
figure below.
Cross-cutter unit
Protective cover