Table of Contents
Advertisement
6-26
4
5
6
7
8
A DV A N C E D F U N C T I O NS AN D O P E R AT I O NS : S e t ti n g th e R eg i s tr a t i o n M a rk M o d e
If you press the F4 key (MANUAL), the following message appears.
MOVE TO MARK 1
USE THE POSITION KEY
TO MOVE THE PEN AND
THEN PRESS ENTER!!
Use the POSITION keys to move the pen tip to MARK 1 (Point 1), and then
press the ENTER key.
Registration mark pattern 1
Point 4
Point 2
Point 1 (the desired
Origin Point)
Point 3
Move the pen tip within this area
When Point 1 has been scanned, move the pen tip to MARK 2 (within the Point
2 area) then to MARK 3 (within the Point 3 area), and finally to MARK 4 (within
the Point 4 area), and perform the same operation as for Point 1.
When all four points have been scanned automatically or manually, the display
changes to the following (only displayed if OFF has been selected for
DISTANCE ADJUST). The measured value for the distance between points 1
and 2 is shown in the 3rd row. Set the actual distance in the 4th row.
DISTANCE
POINT 1-2
OK?
Use the (
) POSITION keys to increase or decrease the value.
Press the ENTER key to register your setting. The display changes to the
following (only displayed if OFF has been selected for DISTANCE ADJUST).
The measured value for the distance between points 1 and 3 is shown in the
3rd row. Set the actual distance in the 4th row.
DISTANCE
POINT 1-3
OK?
Use the (
) POSITION keys to increase or decrease the value.
Press the ENTER key to register your setting.
When adjustment has been completed, the plotter returns to Ready status.
Registration mark pattern 2
Point 4
Point 2
Point 1 (the desired
Origin Point)
Point 3
Move the pen tip within this area
00099.8 mm
00100.0 mm
00101.1 mm
00100.0 mm
Advertisement
Table of Contents
