Table of Contents
Advertisement
6-58
6.31 Selecting the Type of Perforated Line
The CUT LINE PAT. function lets you specify one of seven types of cut lines from 1
to 7. If you select OFF, a solid line is cut. The default setting is OFF. Change this
setting if the shapes being cut either separate too easily or are hard to separate.
Using this function, you can select the cut line pattern ratio (the ratio of cut
segments to uncut segments in each line) by specifying the LINE TYPE NO. The
smaller the value, the shorter the uncut segments and the easier it is for cut
shapes to be separated. When the specified LINE TYPE NO. properly suits the
medium you are using, cut shapes can be easily separated after cutting but will not
com loose during cutting.
The uncut segment lengths left are as shown below for 8 mm cut line lengths.
1
2
3
4
5
6
7
A DV A N C E D F U N C T I O NS AN D O P E R AT I O NS : S e l e ct i n g t h e T y p e o f P e r f o r at e d L i n e
• Pattern 1: 0.20 mm
• Pattern 2: 0.25 mm
• Pattern 3: 0.30 mm
• Pattern 4: 0.35 mm
• Pattern 5: 0.40 mm
• Pattern 6: 0.45 mm
• Pattern 7: 0.50 mm
S
O
ETTING
PERATION
Press the MENU key.
Press the NEXT key until the following menu appears.
Press the F3 key (FUNCTION 1). The following menu appears.
Press the F1 key (PERFORATION PATTERN). The following menu appears.
Press the (
)POSITION keys to change the pattern number.
Once the desired pattern number has been selected, press the ENTER key.
Press the MENU key to return to Ready status.
INTERFACE >
AREA PARMETERS >
FUNCTION1 >
FUNCTION2 >
PREF. LINE TYPE >
ROTATE >
MIRROR >
SCALE >
CUT LINE PAT NO.
LINE TYPE NO. = OFF
[F1]
[F2]
[F3]
[F4]
[F1]
[F2]
[F3]
[F4]
[F1]
[F2]
[F3]
[F4]
Advertisement
Table of Contents
