Table of Contents
Advertisement
7-2
7.1 Loupe (PHP61-LOUPE)
Axis Alighment and plotting Area Adjustment
The loupe (bombsight) is used to align points for adjustment during axis alignment
operations, and to align the corner points when specifying the plotting area. It
indicates the current pen position, and is used for fine adjustment. The loupe is
mounted in the pen holder.
Attaching the Loupe
1
2
3
O P T I O N S : L o u p e ( P H P 6 1 -L O U P E )
Loosen the pen holder screw. (See Section 1.5, "Attaching a Cutter Pen")
While holding the pen holder upward, push the loupe all the way into the holder
until the flange contacts the upper part of the pen holder.
Note: Use the same procedure to attach the loupe to the pen holder of the
2-pen model.
Upper part of pen holder
Holder for auto registration mark sensor
Make sure that the pen bracket is mounted firmly over the flange, and then
tighten the screw.
Note: Use the same procedure to attach the loupe to the pen holder of the
2-pen model.
Holder for auto registration mark sensor
Flange
Flange
Pen bracket
Advertisement
Table of Contents
