Table of Contents
Advertisement
6.14 Selecting the Registration MARK TYPE
This function is used to select the registration mark pattern that is printed on the
media.
1
2
3
4
5
6
7
A D V A NC E D F UN C T I O N S A N D O P E R A T I O N S : S e l e c t i n g t h e R eg i s t ra t i o n M A R K T Y P E
S
P
ETTING
ROCEDURE
Press the AXIS/R.M.S. key.
If the registration mark mode has been enabled, the following menu appears.
Note: If the registration mark mode has not been set, the axis alignment
menu screen appears. If you wish to use the registration mark functions,
press the NEXT key to cancel the operation and then refer to Section 6.12,
"Setting the Registration Mark Mode" for details on how to make the
registration mark mode settings.
Press the F1 key (AUTO REG. MARK). The following menu appears.
Note: The following display can also be accessed from the INITIAL menu
screen that is displayed when the media set lever is not engaged.
Note: DISTANCE ADJUST is not displayed if media has not been loaded in
the plotter.
Press the F2 key (MARK TYPE). The following menu appears.
The asterisk "*" indicates the currently selected setting.
Press the F3 key (1) to select pattern type 1.
Press the F4 key (2) to select pattern type 2
Registration mark pattern 1
Press the ENTER key to register your setting.
Press the NEXT key to return the plotter to Ready status.
This setting is retained in the plotter's internal memory even when the power is
turned off.
AUTO REG. MARK>
SKIP>
AUTO>
MANUAL>
MARK SCAN MODE>
MARK TYPE>
OTHER SETUPS>
DISTANCE ADJUST>
MARK TYPE
TYPE 1*
TYPE 2
Registration mark pattern 2
6-29
Advertisement
Table of Contents
