Rs-232C Interface; Factory Preset Settings - GRAPHTEC FC7000 Series User Manual

Cutting pro
Hide thumbs Also See for FC7000 Series:
Table of Contents

Advertisement

10-2

10.1 RS-232C Interface

To use the RS-232C Serial interface, it is necessary to specify the COMMAND
mode, either the STEP SIZE parameter (when the COMMAND setting is GP-GL) or
the ORIGIN parameter (when the COMMAND setting is HP-GL), and the RS-232C
interface conditions. You can specify the interface settings at the plotter's control
panel. Set the interface conditions to the same settings for your software
application and for the plotter. If they are incorrectly set, the plotter may display an
error message, fail to properly receive all of the data transmitted from the
computer, or malfunction. In such cases, check your interface conditions once
more. For instructions on setting the required parameters, see 6.3, "Setting the
ORIGIN in HP-GL Mode ", Section 10.4 "Setting the STEP SIZE ", and Section
10.6 "COMMAND Settings".
F
P
S
ACTORY
RESET
ETTINGS
RS-0
9600 BAUD
8
BIT
NONE PARITY
HARDWIRE
I N T E R F A C E S : R S - 23 2 C I n t e r fa c e

Advertisement

Table of Contents
loading

Table of Contents