Table of Contents
Advertisement
6-52
6.26 Adjusting the Blade OFFSET ANGLE
The FC7000 controls the angle of the cutter blade tip based on changes in the
angles in the cutting data. This setting specifies the reference angle that
determines whether angle control is applied. Specifying a large reference angle
will shorten overall cutting time by reducing the time required for blade control,
since the plotter will control the blade only for large variations in the angle.
However, setting an extremely large angle may produce cutting results that fail to
reproduce the intended image.
1
2
3
4
5
6
7
A DV A N C E D F U N C T I O NS AN D O P E R AT I O NS : A d j u st i n g t h e Bl a d e O F F S E T AN G L E
S
P
ETTING
ROCEDURE
Press the MENU key.
Press the NEXT key until the following menu appears.
Press the F3 key (OPTION 1). The following menu appears.
Press the F2 key (OFFSET ANGLE). The following menu appears.
Use the (
) POSITION keys to increase or decrease the value in the range
from 0 to 60.
Press the ENTER key to register your setting.
Press the MENU key to return the plotter to Ready status.
This setting is retained in the plotter's memory even when the power is turned
off.
PEN UP/DOWN>
BACKGROUND SETTINGS>
OPTION 1>
OPTION 2>
PEN UP SPEED>
OFFSET ANGLE>
OFFSET FORCE>
STEP PASS>
OFFSET ANGLE
ANGLE = 30
Advertisement
Table of Contents
