Table of Contents
Advertisement
1 - 8
4
Socket head
cap screws
Positioning pin hole
Caster stoppers
5
O u t o f t h e B o x : A ss e m b l i n g th e p l o tt e r
Mount the plotter on the stand by inserting the positioning pins on the stand
into the positioning holes on the underside of the plotter. Fasten with four
socket head cap screws (two on each side), using the Allen wrench.The cutting
plotter mounting direction is different for the front loading and the rear loading
models.
<Front loading>
Socket head
cap screws
Positioning pin
Tighten the socket head cap screws loosely fastened in Step 2.
• Check that all of the screws used for fastening have been tightened. The media
may not be fed correctly if even one of the screws is loose.
• When installing the plotter, make sure that there are no objects in its vicinity.
Leave a clear space of at least 300 mm around the plotter.
<Rear loading>
Advertisement
Table of Contents
