Table of Contents
Advertisement
7
Turn the blade length adjustment knob in the clockwise direction to extend the
blade. Press the F4 key (CHECK) to coufirm direction of the cutter blade once
again. The current extended blade length is displayed. Continue to adjust the
blade length until it is extended sufficiently to enable cutting of thick media.
8
Press the F2 key to start test cutting. Check the cut results when test cutting
has been completed.
P en S e t ti n g Co n d i ti o n s : Ad j u s t i n g t h e B l a d e L en g t h
BLADE ADJUST>
The blade is extended or retracted
TEST 1>
approximately 0.5 mm with each turn.
TEST 2>
CUTTING PRO>
The value is
decreased
4-11
The value is
increased
Advertisement
Table of Contents
Need help?
Do you have a question about the FC7000 Series and is the answer not in the manual?