Table of Contents
Advertisement
Holder for auto registration mark sensor
Setting the pouncing conditions
This function specifies the interval between the holes used to create a continuous
punched outline.
1
2
3
4
5
S
P
ETTING
ROCEDURE
Press the F1 to F4 key that corresponds to the number of the setting area (the
condition number) that you wish to change.
Press the CONDITIONS key to display a conditions setting mode menu as
follows.
Note: The conditions that are actually displayed will vary according to the
selected cutter-pen condition setting area.
Press the F4 key to display the blinking cursor at the position shown in the
following menu.
Use the (
) POSITION keys to select POUNCE.
Use the (
) POSITION keys to increase the value in the range from 1 to 99
(mm).
Press the ENTER key to register your setting. To exit the conditions setting
mode, press the NEXT key before pressing the ENTER key.
SET
14
CONDITION
1
30
4
CB09Ux 0
SET
14
CONDITION
1
30
4
POUNCE
1
O P T I O N S : P o u n c i n g T o o l
7-5
Advertisement
Table of Contents
