Table of Contents
Advertisement
6-28
4
5
6
7
A DV A N C E D F U N C T I O NS AN D O P E R AT I O NS : S et t i n g t h e R e g i s t r at i o n M ar k R ea d i n g A r e a
Note: The following display can also be accessed from the INITIAL menu
screen that is displayed when the media set lever is not engaged.
Note: DISTANCE ADJUST is not displayed if media has not been loaded in
the plotter.
Press the F1 key (MARK SCAN MODE). The following menu appears.
Press the F3 key (ON), and then press the ENTER key. The following menu
appears.
MARK SCAN MODE
Make your selection and then press the ENTER key. The following menu
appears.
MARK POSITION
• Setting the registration mark reading area reduces the mark-sensing time.
Moreover, sensing of the marks is not affected even if there is a drawing or dirt
between the marks.
• Up to three registration-mark spacing settings can be stored.
Press the F3 or the F4 key to select the X or Y axis for setting the distance.
Use the ((
) POSITION keys to move the blinking cursor to the left or right,
and the (
) POSITION keys to increase or decrease the value.
Press the ENTER key to register your setting.
This setting is retained in the plotter's internal memory even when the power is
turned off.
MARK SCAN MODE>
MARK TYPE>
OTHER SETUPS>
DISTANCE ADJUST>
MARK SCAN MODE
ENABLED*
DISABLED
2POINTS
3POINTS*
4POINTS
X=
00 0 mm
0
X=
0000 mm
Advertisement
Table of Contents
